Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND CONFIGURATION
DEVICE ATTACHMENT
The device attachment can be done through the blind holes (1) by using 4 mm diameter self-tapping screws. The
attachment holes (2) are used in case of flush mount installation by using the screws supplied.
If required, the equipment can be fixed from its inner part following the next procedure:
1. Remove the screws (3) and remove the front cover (4).
2. Remove the plugs (5).
3. Fix the back cover of the equipment (6), previously wired, with 2 screws (7).
4. Wire the electronic board, reassemble the front cover (4) and fix the screws (3).
Ø4 self-tapping screw
2
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
1
CAN 1
SV 1
SV2
PULSER
CAN 2
5
6
7
R. 06/18 838 849
EN
4
3
5
Tabla de contenido
