Sanus MC1A Manual De Instrucciones página 9

CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:

Pilot holes MUST be drilled to a depth of 63.5 mm (2.5 in.), using a 5.5 mm (7/32 in.) diameter drill bit.

DO NOT over-tighten the lag bolts [05].

Drywall covering the wall must not exceed 16 mm (5/8 in.).
Wood Joist Ceiling Mounting
CAUTION:
Minimum wood stud size: common 51 x 102 mm
(2 x 4 in.) nominal 38 x 89 mm (11/2 x 31/2 in.)
1. Locate joist. Verify the center of the joist with an awl or thin
nail or use an edge to edge joist finder.
2. Align the ceiling plate [01] and mark the hole locations.
3. Drill pilot holes as illustrated.
4. Tighten the lag bolts [05] only until the washers [06] are
pulled firmly against the ceiling plate [01].
2
4
6901-002094 01
13mm
5.5 mm
(1/2 in.)
(7/32 in.)
CAUTION:
[01]
[06]
[05]
1
≤ 16 mm
(5/8 in.)
3
2
63.5 mm
2.5 in.
9