CMT ORANGE TOOLS CMT650 Manual De Instrucciones página 6

General safety instructions...
Cutters and Collets
When cutting worktops the abrasive nature of the chipboard core and
laminate faces rapidly wears the cutting edges of any cutter including
tungsten carbide tipped cutters. Any cutter is unlikely to cut more than
three complete worktop joints perfectly cleanly (i.e. male and female
parts). Ensure that cutters are cleaned and sharpened (hand sharpened
on a diamond stone) between cutting each complete joint.
Ensure that the cutter is correctly held in the router collet
(see router manufacturers instruction manual)
Always check that the guide bush is fitted concentric to
the cutter, preferably using a centering mandrel.
www.cmtutensili.com
6