Ice Maker And Water Filtration System - JENN-AIR Euro JUD24FRS Serie Manual De Uso Y Cuidado

Over Temp Alarm
NOTE: If the Over Temp Alarm activates, your food may spoil.
See "Power Interruptions." Minimize opening of drawers until
temperatures return to normal.
The Over Temperature feature is designed to let you know when
either the refrigerator drawer temperature rises above 45°F (7°C)
or the freezer drawer temperature rises above 6°F (-14°C) for
4 hours or longer. The audio alarm will shut off automatically
when the temperature returns to normal. To let you know an Over
Temperature condition occurred, the indicator light will continue
to flash until the Reset Alarm touch pad is pressed.
If the over temperature condition is still present when an Over
Temp reset is performed, the indicator light will continue to
reactivate every 4 hours until refrigerator and freezer
temperatures are below 45°F (7°C) and 15°F (-9°C), respectively.
NOTE: These features will not appear on your control unless your
refrigerator is over temperature and the alarm requires a reset.
Showroom Mode
This mode is used only when the refrigerator is on display in a
retail store. If you unintentionally turn on Showroom mode, Cool
Off will light up on the display, and the controls will appear to
work. Exit Showroom mode by pressing and holding COOL ON
and SABBATH at the same time for 3 seconds.
Ice Maker and
Water Filtration System
(Refrigerator/Freezer Drawers only)
IMPORTANT: After connecting the refrigerator to a water source
or replacing the water filter, fill and discard three full containers of
ice to prepare the water filter for use before using ice.
Turning the Ice Maker On/Off
IMPORTANT: Use the Icemaker touch pad on the control panel
to turn on or off the Icemaker. Do not adjust the wire arm located
on the ice maker.
Press the ICEMAKER touch pad to turn on the ice maker.
The indicator will illuminate when On.
Press the ICEMAKER touch pad to turn off the ice maker.
REMEMBER:
Allow 24 hours to produce the first batch of ice.
The quality of your ice will only be as good as the quality
of the water supplied to your ice maker.
Avoid connecting the ice maker to a softened water supply.
Water softener chemicals (such as salt) can damage parts of
the ice maker and lead to poor quality ice. If a softened water
supply cannot be avoided, make sure the water softener is
operating properly and is well maintained.
Do not store anything in the ice storage bin.
Water Filtration System
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system.
Water Filter Indicator / Reset Filter
The water filter indicator will help you know when to change your
water filter. The indicator will change from dark to yellow when it
is time to order a new filter.
The indicator will then change from yellow to red when it is time
to replace the water filter.
The disposable water filter should be replaced at least every
6 months. After replacing the water filter, reset the water filter
indicator.
Press and hold RESET FILTER for 3 seconds. The indicator
light will turn Off.
NOTE: These features will not appear on your control unless
you need to order or replace your filter.
Changing the Water Filter
The water filter is located through the base grille. You do not have
to remove the base grille in order to change the water filter.
1. Locate the water filter cap in the front base grille. Rotate the
cap counterclockwise to a vertical position and pull the cap
and water filter out through the base grille.
NOTE: There will be water in the filter. Some spilling may
occur.
2. Remove the filter cap by sliding it off the end of the old filter.
The cap will slide to the left or right.
IMPORTANT: Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
13