Elnur Gabarron ECOMBI PLUS ECO15 PLUS Instrucciones De Instalación página 24

4.- REMOTE OPERATION USING THE WIFI G-CONTROL HUB
It is possible to control the full operation of the unit remotely with the Elnur Gabarron Wifi Control app or the app-web
(https://remotecontrol.elnur.es). The unit must be connected to a Wifi G-Control Hub connected to the internet to use this
feature.
To associate the Ecombi Plus unit to the G-Control Hub, follow the instructions of the installation wizard of the app.
- Open the application and login with your user and password.
- Access the heating menu in the app.
- Press the button Add (+) and select the type of heater that you are going to connect (Storage heater).
- Press Start Search and follow the instructions of the installation wizard.
When required, keep pressed
heater display.
You can now control and adjust the programming and temperatures on the Ecombi Plus via the Elnur Gabarron Wifi Control
app or the app-web (https://remotecontrol.elnur.es).
5.- TROUBLESHOOTING
ECOMBI PLUS does not heat.
ECOMBI PLUS does not reach
set up temperature
"Err" Message in display
Keyboard does not respond
ECOMBI PLUS does not
communicate with the G
Control Hub.
on the storage heater for 3 seconds until the Link symbol
Please check it is connected and switched on.
Make sure the device is not covered or the lower air inlets are not obstructed. The LR safety limit
may be activated; in this case it is necessary to reset it manually. Please contact technician.
Make sure that adequate temperature is selected.
Make sure the storage heater is sized correctly for heat loss.
Please contact technician.
If the symbol is displayed, the keyboard is locked. Hold "+" and "-" buttons simultaneously for 3
seconds to unlock the keyboard. (See Keyboard Lock Section).
If the symbol is displayed blinking, the keyboard has been locked remotely. Use the app to unlock
the keyboard.
Check the unit is associated, the symbol
For distances greater than 30 metros and 2-3 walls, associate first the closest units. Each unit can
work as signal extender.
If symbol is flashing, check the G Control Hub connexion to the network, and if any other
device in the RF Net that could be working as signal extender has been removed.
must be shown on the display LCD.
23
is displayed in the storage