1 – Unlocking the handle and security
When the handle is in the locked position, a safety latch locks it in position.
Simply release the safety latch by lifting the tab (View A) to loosen the handle.
You can lock this latch in place for added safety (View B) and to protect the cycle carrier
against theft.
2 – Open the handle to maximum extent
3 – Position the bike carrier on the tow ball
4 – Lift up the handle to tighten the bike carrier on the tow ball
Hold the cycle carrier horizontally, then move the handle (to make it easier, you can use your
foot to begin with).
You must feel some resistance to ensure optimum tightening. To do this, you must adjust the
carrier's pressure screw (make this adjustment with handle loose).
The tightening force must be equal to 40 kg.
After tightening, if you can see the triangle, the bike carrier is not secured.
Tighten the adjustment screw manually. If it is too hard, you can use a 6mm Allen key.
IMPORTANT: Make any adjustments with clamping handle loose
5 – Unfold the cycle support arms
6 – Unfold the number plate support
7 – Unfold the lights and fit the number plate
Carrier can be protected against theft.
(to lock:
push)
8 – Bike positioning
Use the ramp to ride the bike more easily
Loosen the bike frame support to move it
Tighten the bike frame support to lock it in the desired position
The heaviest bike must be positioned closest to the car.
We highly recommend that the chain and crank of the 1st bike be positioned facing towards the
car. Tighten the bike frame firmly, using the tensioner.
If necessary, the possibility of moving the gutters. Install the bikes facing in alternate
directions
strapping final
strap bicycle frames together around the central arch
Each bicycle wheel must be strapped to the bow vertical
9 – Tilting of bike carrier to allow boot hatch access
Press the pedal with your foot to swing the bicycles down.
For a more convenient boot opening, you can remove the handle.
CAUTION: don't forget to put the handle back after closing the boot.
To reset bike carrier, just raise it back to its original position.
The cycle carrier's electrical connector fits both a 7-pin and a 13-pin connector.
Unscrew the front part of the plug for 13-pin access.
10 – Lifting the bikes off
To release the strap that holds the bike frames, you must turn the tensioner back on itself and
push.
11 – Folding the lights
To fold in the lights, push in the buttons to disengage the lights from the centre part.
12 – Lift up the light plate and bike support arms
13 – Unlocking the security and the handle
