Cleaning And Calibrating; Cleaning The Scanner; Calibrating The Scanner; Helpful Hints - Philips SIC4014H/G7 Manual Del Usuario

Cleaning and Calibrating

• To get high image quality and good recognition results, please perform the
step below from time to time.
• Make sure the cleaning cloth and calibration paper are clean and free of
dust before use.

Cleaning the scanner

• Wipe the scanner lens lightly using the supplied cleaning cloth.
• Do not use any solvent to clean the scanner.
• Do not use rough material such as nylon scouring pad to wipe the scanner.

Calibrating the scanner

1. Place the calibration paper on a fl at
surface with the white side facing up.
2. Turn on the scanner.
3. Select CALIBRATION by following the
steps below: SETTING > SCAN SETTING > CALIBRATION> Yes.
4. Hold the calibration paper fi rmly by one hand, with the other hand slide
forward/backward the scanner slowly against the paper. The calibration
starts.
5. When the calibration is done, a message "Complete" appears and the
scanner will shut down automatically.

Helpful Hints

• Why isn't the scanner turning on?
Please push to open the battery compartment to verify that all batteries
are installed properly.
• Why won't the memory card fi t?
Philips Glide only uses microSD cards. While inserting the memory card,
push the card in with metal side face up, until the "click".
To remove the card, simply press down on the card. Memory card will
push out automatically.
• Why isn't the scanned image clear?
It is recommended to clean scanning sensor before usage with supplied
cleaning cloth. Scanning at a consistently slow speed will increase
scanning quality.
10