Preparing Before Use - UPRtek MK30S PREMIUM Manual Del Usuario

2.1 Preparing Before Use

Battery installation
Remove the back cover from underneath the MK350S
1
Premium by inserting your fingernail into the notch,
located below the end of the cover, and sliding your
nail along the underside of the edge to unhinge one
side - do the same for the other side.
Install the battery as shown with the correct
2
orientation. The battery will install in only one
direction – do not force the battery in.
Replace the back cover.
3
Charge the battery full for 6 hours before using it for the first time.
1.
To prevent power outage during using this product, please check whether the red light has
2.
turned off (fully charged) according to instructions given in next page item1. Once this product
is enabled keep an eye on indicator of balance of battery charge at upper right corner of
screen.
In case a battery goes exhausted soon after fully charged then its life cycle has ended. Please
3.
call your dealer for replacement with new one.
4. Time span your battery can last varies with its life cycle. Newly shipped battery after full charge
may last around 5 hours.
English
- 5 -
2.1 Preparing Before Use
Battery charging
Connect charger to charging port of this product to start charging its battery.
1. Product in off mode: The Battery Recharge LED lights red during battery charging and
turns off after it is fully charged.
2. Product in on mode: A flash symbol displays at upper right corner of screen of this
product during charging and disappears after it is fully charged.
- 6 -