Intimus 1632 Manual Del Usuario página 6

2.0 Parts
1. Power Cord
2. Conveyor Belts
3. Holdback Assembly
4. Bottom Blade
5. Top Blade
6. Feed Deck
7. Top Housing
8. Bottom Housing
9. Chassis
10. Blade Cover
3.0 Installation
3.1 Unpacking
Carefully unpack the letter opener . The rubber feet are in a separate bag. Place all of the
packing material back in the shipping box and store the box for any future shipment of the let-
ter opener. Inspect the letter opener and all accessories for shipping damage. If any damage
is found, contact the carrier immediately.
3.2 Assembly
Make sure the machine is OFF as denoted by the 'O' symbol on the power switch. Plug the
power cord into a 230 Volt, 50-60 Hz outlet. The letter opener is now ready to be put into use.
Place the letter opener on a flat, level surface where it will be used. It is necessary to have a
clear area next to the letter opener for the opened letters and scrap to fall.
*Note: The letter opener sits at an angle. This is normal.
4.0 Operation
4.1 Preparing Envelopes
Sharply tap the stack of envelopes to be opened against the tabletop or other hard object. This
will settle the contents to one side, allowing the opposite side to be opened without cutting
into the contents.
4.2 Loading Envelopes
With the letter opener OFF, place the stack of
envelopes on the feed deck with the side to be
opened flat against the back side of the deck and the
leading edge of envelopes against or even with blade
cover (see photo at right). NOTE: Do not push any
portion of the stack underneath the blade cover.
6 2 3
8
6
5
4
10
7
9
1