Uline H-8271 Guia De Inicio Rapido página 2

4. Locate the access hole on the bottom of the base.
(See Figure 4) Hold down the sealing arm and loosen
the screw visible through the access hole. Do Not
remove the screw. Remove the nichrome sealing
wire. Hook the new wire around the screw and
tighten, making sure the new wire is properly aligned.
CAUTION! Do not remove the screw.
5. Align the ring terminal of the new wire with the
threaded hole of the phenolic assembly. Replace
the screw removed in Step 3 to secure the new wire.
6. Slide phenolic assembly back in place with flat side
of insulator facing the arm.
7. Replace insulator sleeve (I) and end cap (H) and
tighten screw (G).
PAGE 2 OF 6
NICHROME WIRE REPLACEMENT CONTINUED
Figure 4
1-800-295-5510
uline.com
0621 IH-8271