goliath TIJA G-AC016 Manual Del Usuario

EN
GOLIATH G-AC016
USER'S MANUAL
360º TIJA CLAMP
WHAT YOU WILL FIND IN THE BOX:
1 360º TIJA clamp body
1 Standard rear washer for clamp and 1 xing screw
3 Axes for the di erent frames, with adjustment handle
DESCRIPTION AND TECHNICAL CHARACTERISTICS:
The 360º TIJA clamp (G-AC016) is an alternative to the classic clamp, specially designed for
mounting bicycles.
Compatible with all the stands of the GOLIATH BIKE line, the 360º TIJA clamp allows you to
t the bicycle frame where the seat post is attached.
It includes 3 shafts of di erent sizes to t most frames on the market, allowing a solid and
versatile t.
Originally conceived to mount only the frame and to assemble all the parts of the bicycle to
it, the 360º TIJA clamp allows a complete vertical rotation in 360 degrees and also a
rotation on itself of approximately 90 degrees.
Ideal for the professional who does not want to hold the bikes directly to the frame or for more delicate frames such as carbon ones, simply replace the
seat post with the corresponding axis of the 360º TIJA clamp.
The 3 included axles are designed for the following seatpost diameters:
27.2 mm | 30.9 mm | 31.6 mm
ASSEMBLY INSTRUCTIONS:
MOUNTING THE CLAMP ON ANY SUPPORT IN THE GOLIATH RANGE:
1- Remove the 360º BASIC clamp from the support, loosening the rear screw and removing the
stop washer. (Photo 1)
2- Remove the rear washer from the 360º TIJA clamp by loosening the screw.
3- Proceed to replace the original clamp with the 360º TIJA clamp, xing the rear stop washer by
means of the screw.
INSTRUCTIONS FOR USE:
The 360º TIJA clamp behaves in the same way as the 360º BASIC clamp, so you can perform any
task that you normally do on your GOLIATH mount.
1- With the clamp mounted on the stand, loosen the side handle.
2- Select the axis that suits the frame you are going to work on and proceed to insert it into the
clamp. (Photo 2)
3- Tighten the side handle to x the axle to the caliper.
4- Place the bicycle frame by inserting the clamp axle into the hole where the seat post is
normally housed and tighten the upper handle of the axle, allowing it to adjust to the frame.
5- Once the frame is secured, you can proceed to tilt it, for this loosen the side handle and close it
again in the desired position.
* In case the frame is not well secured, try one of the axes of another measure. Each normally has a tolerance of a couple of
millimeters, but it is always best to use the correct axis for each frame size.
DANGER WARNINGS IN THE USE OF THE 360º TIJA CLAMP:
It is important to be careful with the clamping pressure that the clamp
exerts on the frame to be held, since although the clamp is designed not
to damage it, if we press the frame excessively, it could crack the paint or
permanently damage it.
We must operate with responsible use and professional caution.
1
2
MAINTENANCE:
1- The clamp does not need any speci c maintenance.
2- The only greasing points can be the clamp and extension nut threads,
which must be lubricated with a little grease, petroleum jelly, etc.
This greasing process should be done to the user's liking and although it
is not necessary, it does contribute to smoother movements.
WWW.GOLIATH-BIKE.COM