Desescarche; Como Actuar Si El Aparato No Funciona - CORBERO FD 5161 S/5 Libro De Instrucciones

Tabla de contenido
MAINTENANCE
Unplug the appliance before carrying out
any maintenance operation.
Warning
This appliance contains hydrocarbons in its cooling
unit; maintenance and recharging must therefore
only be carried out by authorized technicians.
Periodic cleaning
Clean the inside with warm water and bicarbonate of
soda.
Rinse and dry thoroughly.
Clean the condenser (black grill) and the compressor at
the back of the appliance with a brush or a vacuum
cleaner. This operation will improve the performance of
the appliance and save electricity consumption.
Interior light
If the light does not come on when the door is open,
check that it is screwed into place properly. If it still
does not light up, change the bulb.
The light bulb inside the refrigerator compartment
can be reached as shown in the figure.
The rating is shown on the light bulb cover.
D411
Periods of non-operation
When the appliance is not in use for long periods,
take the following precautions:
remove the plug from the wall socket;
remove all food;
defrost and clean the interior and all accessories;
leave the door ajar to allow air to circulate to prevent
unpleasant smells.
14
Defrosting
Frost is automatically eliminated from the evaporator
of the refrigerator compartment every time the motor
compressor stops, during normal use. The defrost
water drains out through a trough into a special
container at the back of the appliance, over the
motor compressor, where it evaporates.
It is important to periodically clean the defrost
water drain hole in the middle of the refrigerator
compartment channel to prevent the water
overflowing and dripping onto the food inside.
D037
Use the special cleaner provided, which you will
find already inserted into the drain hole.
The freezer compartment, however, will become
progressively covered with frost. This should be
removed with a plastic scraper, whenever the
thickness of the frost exceeds 4 mm. During this
operation it is not necessary to switch off the power
supply or to remove the foodstuffs.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
as follows:
1. pull out the plug from the wall socket or turn the
thermostat knob to the «O» setting;
2. remove any stored food, wrap it in several layers
of newspaper and put it in a cool place;
3. leave the door open;
4. when defrosting is completed, dry the interior
thoroughly and refit the plug;
5. turn the thermostat knob back to the required
setting or replace the plug in the power socket.
After two or three hours, reload the previously
removed food into the compartment.
Important:
Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it.
Do not use a maechanical device or any artificial
means to speed up the thawing process other
than those recommended by the manufacturer.
A temperature rise of the frozen food packs,
during defrosting, may shorten their safe storage
life.

Desescarche

La escarcha del evaporador del compartimento refri-
gerante se elimina automáticamente a cada interrup-
cion del motocompresor. El agua de la escarcha der-
retida, mediante un canal adecuado, se recoge en un
pequeño depósito colocado en la parte posterior
sobre el motocompresor del aparato, de donde
evapora.
Se recomienda limpiar periódicamente el agujero
de desagüe del agua de desescarche, situado en
la parte central del canal en el compartimiento
refrigerante, utilizando el «limpiador» adecuado
que se encuentra en el agujero, para evitar que el
agua de desescarche caiga sobre los alimentos.
En el compartimento congelador la escarcha deberà
á ser eliminada cada vez que se haya formado una
capa de aproximadamente 4 mm de espesor,
utilizando un raspador en plástico. Durante esta
operación no es necesario interrumpir la conexión
electrica o quitar los alimentos contenidos en el
compartimento.
En el caso que se formara una espesa capa de
hielo, será necesario descongelar totalmente el
congelador, procediendo de la manera siguiente:
1. Colocar el mando del termostato en posición
«0», o desenchufar el aparato.
2. Envolver los alimentos congelados en varios
papeles de diario y colocarlos en un lugar muy
fresco.
3. dejar la puerta abierta;
4. una vez terminado el desescarche secar

COMO ACTUAR SI EL APARATO NO FUNCIONA

Si el aparato presentase anomalías será oportuno
controlar:
Que esté bien enchufado y que el interruptor de
la instalación eléctrica esté conectado.
Que no haya un corte de energía eléctrica.
Que el mando del termostato se encuentre en su
posición correcta.
Si el compresor funciona sin interrupción,
verificar que el termostato no se encuentre en
una posición muy alta.
Además si el aparato hace demasiado ruido
verificar que los costados no estén en contacto
D037
cuidadosamente el compartimento congelador e
introducir el tapón de cierre.
5. girar el mando del termostato en la posición
deseada o volver a enchufar el aparato. Después
de dos o tres horas de funcionamiento el aparato
está de nuevo listo para la conservación de los
alimentos ultracongelados.
Atención
Se recomienda no utilizar utensilios metálicos
para quitar la escarcha a fin de evitar graves
daños al aparato.
No usar dispositivo mecánico alguno u otro
medio artificial para acelerar el processo de
desescarche excepto los recomendados.
Un aumento de la temperatura de los alimentos
ultracongelados durante el desescarche podría
reducir el tiempo de conservación.
con muebles que pueden causar ruidos o
vibraciones y que la unidad refrigerante no vibre.
Si se ven restos de agua en el fondo del
refrigerador comprobar que el orificio de
desagüe de la escarcha derretida no esté
obturado (ver cápitulo Desescarche).
Si después de los controles sugeridos, el defecto
persiste, serà oportuno llamar al Centro de
Asistencia Técnica más cercano.
Es importante en el momento de llamar
proporcionar la referencia del modelo y el
número de matrícula del aparato indicados en el
certificado de garantía o en la tarjeta matrícula.
7
Tabla de contenido
loading

Tabla de contenido