Installation - HAMPTON BAY DSHD19522V1 Guía De Uso Y Mantenimiento

Installation

1
Installing the crossbar assembly
NOTE: Prior to installation, close or cover the sink drain and/or any vents near the
installation site to prevent loss of mounting hardware if dropped.
□
Secure the crossbar assembly (AA) to the outlet box (not included) with the outlet box screws (BB). Tighten until snug.
NOTE: The preassembled mounting screws on the crossbar should protrude
outward.
2
Test fitting backplate on the fixture body to crossbar assembly
□
Remove mounting balls from the crossbar assembly (AA).
□
Fit the backplate on the fixture body (A) to the crossbar assembly (AA) and secure with mounting balls.
Note: The backplate on the fixture body (A) should be snug against the ceiling and the mounting balls.
□
If not, adjust the length of the mounting screws on the crossbar assembly (AA) by unscrewing the preassembled hex nuts.
Then, screw the mounting screws in or out of the crossbar assembly (AA) until the desired length is achieved.
□
Once the backplate on the fixture body (A) is secure, remove the mounting balls and fixture body (A) and proceed to Step 3.
AA
BB
AA
5
Please contact 1-855-HD-HAMPTON for further assistance.
A
Mounting balls
HAMPTONBAY.COM