Tabla de contenido
JUNIOR
EN
TROUBLESHOOTING
6.
TROUBLESHOOTING
PROBLEMS
- LEDs do not come on.
- Insufficient vacuum in bag.
- Impossible to create vacuum
inside the containers.
- Inefficient pump (only for machines
equipped with filter).
- The quality of sealing gets worse
Operating and service manual / Mode d'emploi et d'entretien
Manual de uso y mantenimiento / Ed. 01 - 2011
No power supply.
Damaged power cord.
Blown fuse.
Damage to the vacuum packaging machine.
The bag leaks.
Sharp edges perforate the bag.
Bag opening dirty.
Cover (B) not positioned correctly
Gasket on cover or edge of container dirty.
Liquids sucked during vacuum creation.
Sealing bar dirty.
Bar covering Teflon strip worn.
•
B
CAUSES
•
26
VACUUM PACKING MACHINE
CONDITIONNEUSE SOUS VIDE
MAQUINA DE VACÍO
SOLUTIONS
Insert the plug in a suitable power socket.
Check the condition of the power cord.
Make sure fuse (A) is correctly fitted and not
blown.
Contact an authorized assistance centre.
Contact the Technical Assistance Centre.
Change the type of bag.
Use thicker bags.
Use a new bag, make sure to keep the opening
clean.
Reposition, then redo the vacuum
by pressing down lightly on the cover.
Clean and then redo the vacuum by pressing
down lightly on the cover.
Empty and clean the filter on machines fitted
with that accessory; contact an authorized
assistance centre.
Clean the sealing bar .
Replace the Teflon strip. Contact an authorized
assistance centre.
A
REV. 00 - Cod.: 1500387
Tabla de contenido
