IB Connect PRISMA Manual De Usuario página 13

user manual
11
12
click
13
Insert the screws under the table in the through-
holes you have drilled, lining them up with the
PRISMA SURFACE fixings. Using the same no.
6 ALLEN key, tighten the screws until the product
is completely secured.
Once it is properly secured and the electrical
and/or multimedia connections are in place, it is
necessary to replace the rear cover in its position.
A
To do so, present it as shown in Fig.12 A.
Place the back cover in line with the top of the
PRISMA Fig.12 B.
After aligning the back cover, press downwards
click
lightly on its ends until you hear a click. Fig.12
C.
B
C
The product is fully installed and ready for use,
as shown in Figure 13.
For any enquiries about the product, please
contact:
[email protected]
11 -12