Chassis Indicators - Biamp Vocia VA-8600 Manual

Signal is a tri-color LED that indicates audio signal presence on the channel. Green indicates that the audio signal level is between
-50 dBFS and -3 dBFS, yellow indicates a signal level between -3 dBFS and 0 dBFS, and red indicates clipping.

Chassis Indicators

Amp Fault is a yellow LED that illuminates when a chassis fault has occurred. There are two types of chassis faults that can be reported,
depending on the severity of the problem. Flashing yellow indicates a Warning, which means that some aspect of the VA-8600 or VA-8600c
chassis is not performing within normal specification. Audio may still be passing, but if the condition causing the Warning is not corrected, chassis
failure may occur. Solid yellow indicates a fault, which means that some aspect of the VA-8600 or VA-8600c chassis has failed and audio
may no longer be passing through the device. Use Vocia software to determine the specific type of chassis warning or fault that has occurred.
Activity is a tri-color LED that illuminates to show the configuration status of the VA-8600 and VA-8600c unit. If the LED is dark, there is
no configuration in the unit. A green LED indicates that the unit is configured and a yellow LED indicates that the unit is configured and in
standby. Standby only occurs when a unit has been designated as a redundant device in a configuration where failover is enabled. A red
LED indicates a configuration load failure.
Status is a tri-color LED that indicates the health of the VA-8600 and VA-8600c hardware. A green LED indicates that the unit powered
up normally. A flashing yellow LED is shown briefly during the power-up self test and should turn solid green upon successful start. A red
LED indicates that the unit experienced a problem during the power-on self test.
Power is a green LED that illuminates when power is applied to the unit.
Table 1 . Channel Indicators
LED Row Label
1 AMP FAULT
2 ACTIVITY
3 SIGNAL
4 —
Table 2 . Chassis Indicators
LED Row Label
1 AMP FAULT
2 ACTIVITY
3 STATUS
4 —
1. Only applicable on amplifier modules configured for redundancy operation
2. Only applicable on amplifier modules configured for redundancy operation
VA-8600/VA-8600c FRONT PANEL
Red Yellow
Never Flashing-Warning
Solid-Fault
Never Configured
and in standby
Signal above clip Signal above peak but
threshold (>= 0dBFS) below clip threshold
(> -3dBFS & < 0dBFS)
—
Red Yellow
Never Flashing-Warning
Solid-Fault
Configuration Configured
load failure and in standby
POST Failure Booting (flashing)
—
Green
Never
Configured and active
1
Signal above min. but
below peak threshold
(> -50dBFS & < -3dBFS)
—
Green
Never
Configured and active
2
Boot succeeded
—
5
Dark
No Amp Faults
Not configured
Signal below min.
threshold (< -50dBFS)
— —
Dark
No Amp Faults
Not configured
Did not boot
— —