Klein + Hummel SMS Serie Manual De Instalación página 5

When daisy chaining loudspeakers the second set of terminals may be utilized to continue the chain. The daisy
chain connection between terminals is only made when a loudspeaker is in place or a K-Lock
connector is installed in place of the loudspeaker.
Optionally, the K-Lock
of the wiring chain and lock down mechanical aiming using the integrated laser pointer.
3. Place the bracket protective boot over the K-Lock
on the job site to be complete.
Remove the bracket protective boot and discard. Allow the back cover plate to magnetically snap into place. Set
the loudspeaker transformer tap while paying attention to whether the power draw is indicated next to the
70 V system arrow or the 100 V system arrow. 16 Ohms may be selected for direct drive low impedance
systems.
4. Aim the mounting bracket in the direction desired and tighten adjustments if not already completed when
testing with the K-Lock
5. Thread the safety cable through the eyelet on the K-Lock
point on the rear of the loudspeaker. Join the two ends of the safety cable using the included quick link.
Installation Manual SMS Series
TM
KIT test system may be used at this stage to verify the absence of shorts and polarity
TM
KIT system.
TM
mounting bracket and wait for the dirty work and painting
TM
mounting back plate and also through the safety
English
Klein + Hummel
TM
bridging
3