Battery Replacement; Service / Maintenance - Jura Claris Guia Al Uso Y A La Instalación

Total filtrate volume (from the start of first operation)
5.4
Step Button
1.
2.
3.

6. Battery Replacement

Step Button
1.
1. Loosen the screw (page 3, pos. 6) on the cover (page 3, pos. 7) with a Phillips head screwdriver.
2. Remove the cover and remove the old battery.
3. Insert the new battery (type CR2032) and press downwards (observe the polarity). Then place back the
cover to the housing and tighten the screw.
NOTE: All stored data remain after the battery replacement.

7. Service / Maintenance

Check the CLARIS Flow Sensor for leaks daily.
In the event of a fault, please contact your service contractor.
Press and hold the „PROG" button for approx. 5 sec.
- The digit „1" appears
Once again press and hold the „PROG" button for approx. 5
sec.
- The complete filtrate volume from the start of first operation
appears
Press the „PROG" button once
- The current filter capacity is displayed
On the display appears „BATT"
- The battery is empty and must be replaced
11
Display
Display