Gima 41701/LD Manual De Instrucciones página 28

ENGLISH
28
Step 5:
Put the Elastic diaphragm into the seal seat,make sure the diaphragm edge and
seal seat edge close fitting. Then seal by the seal cover make it as a sealed iso-
lation assembly. If there is no "O" - shaped sealing ring on the plug at the bottom
of the sealing seat ,please set the seal hoop into the groove in the plug position.
Figure 5-1 Figure 5-2 Figure 5-3 Figure 5-4
Step 6:
Make one side of connection tube without plug insert into seal cover and make an-
other side of connection tube insert into motor unit. Then insert the whole isolation
assembly into connector.
Figure 6-1 Figure 6-2