Tabla de contenido
Idiomas disponibles
Idiomas disponibles
a.
Use the provided 3/4" NPT plug to close the unused cable
entry hole.
b.
Attach a conduit connector to the preferred cable entry
hole. Install the conduit and its fitting as instructed by the
manufacturer.
• When installing outdoors, wrap the thread of the
conduit connector with the supplied Teflon sealing tape
to create a water tight seal around the camera
connection and the cable conduit hole. When applying
the Teflon sealing tape, be sure to wrap in the same
direction that the mount will be tightened. This will
ensure the tape does not unravel when installing the
mating parts together.
NOTE: To maintain the junction box's vandal resistant design, only use
vandal resistant conduits.
When installing the HD Bullet Camera outdoors, ensure the
conduit and its fitting are designed for outdoor use. They must
have a suitable IP rating for the environment that the camera
is installed.
4.
Pull the cables through the conduit connector and cable entry
hole.
5.
Mount the junction box.
•
When using the center cable entry hole, make sure there
is a watertight seal when installing outdoors. Apply an
adhesive that is appropriate for the mounting surface
around the cable entry on the back of the junction box.
•
When using the side cable entry hole, make sure it is
facing downwards.
•
Use screws that are appropriate for the mounting surface.
You can use the screws provided with the HD Bullet
Camera.
6.
Install the HD Bullet Cameras as described in the camera's
installation guide.
2
Tabla de contenido
