Controls And Functions - Ground Zero TITANIUM Serie Manual Del Usuario

Controls and functions – GZTA 5125X
5

Controls and functions

1 Speaker terminals For connection of the speakers
GND -> Ground connection
Power terminals
2 REM -> Remote antenna terminal
BATT -> +12 Volt
GREEN – OK
3 Satus indication
RED – Error
Terminal for connection of the RCA wires.
4 Cinch inputs
To avoid failure, please use high quality RCA wires.
5 Input level controller With this controller you can adjust the input sensitivity.
Adjust the crossover for the chosen utilization.
LPF – Only bass frequencies (below 40Hz - 4000Hz) (G
Channel 5: 40Hz – 250Hz) will be reproduced.
FULL – All frequencies will be reproduced.
HPF – Only middle and high frequencies (
6 Mode switch
4000 Hz /
GZTA 5125X:
At LPF adjustment, also the Highpass (Subsonic) is activated.
This equals a Bandpass filter of 5 – 4000 Hz.
Only frequencies from 40 Hz to 4000 Hz (
Hz – 250 Hz) will be reproduced (depending on the LPF filter controller
7 Low pass controller
position). Set the filter switch to „LOW" ("LP") position. Adjust the
variable LPF frequency to the desired frequency using the controller.
Set the filter switch to „HIGH" position.
High Pass controller Adjust the variable HPF crossover frequency to the desired frequency
8
(Subsonic) using the controller. All frequency between 5 and 4000 Hz (
5120X : 40 Hz – 4000 Hz) will be reproduced.
Depeding on the mode switch position, High- or Lowpassfilter can be
9 Filter controller
adjusted in a range from 40 Hz – 4000 Hz with this controller.
Subsonic controller
10 For adjusting the subsonic filter in a range from 10 Hz to 50 Hz.
(GZTA 5120X Channel 5)
This switch allows you to choose the number of used cinch inputs. All
6 channels of
11 Input mode switch cable.
You can chose if the 5
with Cinch input 5/6 or the summation of input 1/2/3/4.
This controller allows you to fit the subwoofer channel of
12 Phase Shift controller
in-phase to the front system.
14 Remote control input For connection of the bass remote control.
Input Mode GZTA 5125X
2: This adjustment allows you to operate all 6 channels using the Cinch- Input Ch 1 and Ch 2. This is
recommended for active operation of a 3 way front system. For using this possibility, connect for example the
front cinch output of your headunit to the Ch 1/2 of the amplifier.
4: The channels 5 and 6 will be operated using the summarized signal from channel 1/2 and 3/4.
This mode is suggestive if channel 5 and 6 are only used as subwoofer channels.
For using this possibility, connect for example the front and rear cinch output of your headunit to the Ch 1/2 and
Ch 3/4 of the amplifier.
6: This adjustment allows you to operate every channel with an own signal. Using this possibility, every channel
can be adjusted by your head unit or processor separately.
ZTA 5120X
GZTA 5125X : over 5 Hz –
GZTA 5120X : over 40 Hz – 4000 Hz ) will be reproduced.
GZTA 5120X Channel 5: 40
GZTA
GZTA 5125X
can be operated with a 2- channel Cinch
th
channel of GZTA 5120X should be operated
GZTA 5120X
6