Tabla de contenido
FOOTSWITCH
(79) Remote Cable
This eight-pin DIN connector is provided for connecting the footcontroller to the amplifier IN/FOOT (38) via the cable included in
the carton. Preferably connections at the footcontroller and the amplifier should be made before the amp is powered up.
(80) Preset Mode
This switches the footcontroller between NORMAL mode (default, LED off) and PRESET mode (LED red).
Quick Boost Feature: As described below, when in preset mode, the 1-9 switches will recall your 9 custom presets.
When you press the switch of the preset that is already active, it will toggle the status of the Master Boost. This allows a quick
way to recall a preset for a solo and get it boosted very quickly (just hit the switch twice!). Otherwise, you'd have to hit it, then
toggle out of preset mode, then hit the Master Boost switch – tap dance! (Of course, you can save the preset with the boost
active, and then the 2nd press would disable the boost.) To make the Master Boost status visual while in preset mode (red LEDs
for mode/preset) the 9/Master Boost LED will blink green when the boost is enabled. (If on preset 9, the color will toggle between
red and green to show preset number and Master Boost on.)
(81) Effects Loop 1 / Preset # 1
NORMAL mode: This turns on Effects Loop 1 when using Channel 1. If selected, the LED will be lit green even if on a different
channel. Also it can be switched on and off even when using another channel. However, Loop 1 will only actually be on when
using Channel 1.
PRESET mode: This selects Preset 1. If selected, the LED will be lit red.
(82) Effects Loop 2 / Preset # 2
NORMAL mode: This turns on Effects Loop 2 when using Channel 2, and also when using Channels 1 and 3 if Loop 2 is set to
Global (refer to point 44). If selected, the LED will be lit green even if on a different channel. Also it can be switched on and off
even when using another channel.
PRESET mode: This selects Preset 2. If selected, the LED will be red.
(83) Effects Loop 3 / Preset # 3
NORMAL mode: This turns on Effects Loop 3 when using Channel 3. If selected, the LED will be lit green and it can be switched
on and off even when using another channel. However, Loop 3 will only actually be on when using Channel 3.
PRESET mode: This selects Preset 3. If selected, the LED will be red.
Tabla de contenido
