Bond signature Serie Manual Del Usuario página 14

TROUBLESHOOTING
Problem
Heating unit won't light
Burner won't light
while using a match
Heating unit emits a lot
of black smoke
Sudden drop in gas
flow
Flame blows out easily
- - - - - - T T T U U U R R R N N N O O O F F F F F F T T T H H H E E E P P P O O O W W W E E E R R R B B B E E E F F F O O O R R R E E E Y Y Y O O O U U U C C C H H H E E E C C C K K K T T T H H H E E E F F F O O O L L L L L L O O O W W W I I I N N N G G G - - - - - -
Problem
If pump does not run
If hose is blocked
Bond Manufacturing Co., Inc. | Page 14
Cause
Igniter pin and burner are wet
Igniter battery is incorrectly inserted
Igniter pin is broken
Electrode wire is loose or disconnected
Electrode wire is shorting between valve
and igniter pin
No gas flow
Regulator isn't connected securely to the
tank
Gas flow is obstructed
Burner ports are clogged
Flame is obstructed at burner ports
Regulator hose is kinked
No gas flow
Excess flow safety valve has been
activated
High or gusting winds
No gas flow
Excess flow safety valve has been
activated
Check the circuit breaker or try another outlet.
Check the water level in the fountain. Running the pump without
Check the pump discharge and intake for dirt and debris.
The pump might be "air locked." Plug and unplug the pump several
times to release the air inside the pump.
Check and reconnect the cord and try again.
Solution
Dry off with a soft cloth
Check which direction the battery is
inserted
Contact Bond Manufacturing Co., Inc. for
a replacement part
Reconnect wire to the igniter box located
inside the unit behind the igniter box
Contact Bond Manufacturing Co., Inc. for
a replacement part
Check that the gas tank isn't empty
Tighten regulator connection to the gas
tank
Check all hoses for kinks and bends
Turn all gas flow connections off. Insert
an opened paperclip (or similar item) into
each of the burner ports to clear them
out.
Check that all burner ports are free of any
small lava rocks/pumice stones/Lava-
Glass pieces
®
Straighten hose of all bends or kinks
Check that the gas tank isn't empty
Turn the control knob to the 'OFF'
position. Close the tank valve and
disconnect propane gas tank. Turn the
control knob to 'HIGH'; wait 1 minute.
Turn the control knob back to the 'OFF'
position. Reconnect propane gas tank.
Light the fire unit as indicated in the 'To
Light' section of this manual.
Increase flame to 'HIGH'
Check that the gas tank isn't empty
See 'sudden drop in gas flow' above
Solution