Package Contents - PROZIS Hydrus Manual Del Usuario

EN
User manual

PACKAGE CONTENTS

• 1 × Hydrus - Water Flosser
• 1 × USB charging cable
• 1 × Jet nozzle accessory
• 1 × Quick guide
PRODUCT OVERVIEW (SEE PAGE 2)
1. On/Off button
2. Mode button
3. Mode indicator
4. Charging indicator
5. Nozzle
6. Tank cover
7. Water tank
8. Main body
9. Suction pipe
10. Filter
Maintenance and cleaning
Cleaning
Switch the product off and remove all plugs before cleaning!
Do not use aggressive or abrasive cleaning agents to clean the components. They can dam-
age the upper surface of the appliance!
After each use
Open the cover, pour out any remaining water from the water tank, and close the cover again.
Switch on the appliance for a few seconds to remove any remaining water from the pipes
inside the appliance.
Wipe the device with a dry cloth.
Press down the release button and gently pull the nozzle attachment upwards.
Rinse the nozzle attachment under running water and insert it into a holder. Allow it to dry.
Do not immerse the appliance and/or the battery charger in water! The battery charger must
be completely dry before you plug it.
Make sure that moisture does not enter the product while cleaning to prevent damage to the
product and related repairs.
12
Do not clean in the dishwasher or using any other cleaning devices.
General cleaning
Clean the internal parts by adding 2 tablespoons of white vinegar to a full reservoir of water.
Place only the tip inside the sink and switch on the unit. Rinse with a full reservoir of clean
water. Repeat this process every 1-3 months to ensure optimal performance.
NOTE: To prevent bacteria from spreading, make sure no water remains inside the unit. If
you're not going to use this appliance for a long period of time, make sure to wipe it and dry
it thoroughly before storing it.
Storage
Make sure the container is totally dry before storing it .
When no longer using the device, store it in a dry environment, protected from dust and
direct sunlight. Pour out any remaining water from the device and allow all parts to dry com-
pletely before storing them.
Do not store below -30 ºC, above 60 ºC or in humid environments (90% humidity).
If the device is not going to be used for a long period of time, you should recharge it on a
regular basis. This helps maintain battery performance.
Store your device inside the original case provided.
If you are not going to use the device for more than one week, allow the water tank to dry
completely before you place it back onto the device.
NOTE: Replace the tips every 6 months.
INSTRUCTIONS
Charging
1. Insert the cable into the unit and plug it into an USB outlet.
2. The Red LED light indicates that charging is in progress. The green LED light indicates the
device is fully charged. Battery indicator will be steady green when fully charged.
3. Once the battery is fully charged, the charging process will stop due to battery overcharge
protection.
4. Charge the unit for 6 hours prior to its first use.
5. When left to charge, do not place metal objects or water near the device to avoid hazards.
6. If you use the water flosser once a day or less, it is recommended to charge it overnight,
once a week. Do not run the battery down completely as this may shorten its lifespan.
EN
13