Charging Times - HI-Q TOOLS PM400 Guía De Usuario

WHEN RECHARGING THE PM400
LED
25% red LED The 25% Charge LED will slowly
pulse "On" and "Off", when the bat-
tery is less than 25% charged. When
25% 50% 75% 100%
the battery is 25% charged, the Red
Charge LED will be solid.
50% red LED The 50% Charge LED will slowly
pulse "On" and "Off", when the bat-
tery is less than 50% charged. When
25% 50% 75% 100%
the battery is 50% charged, the Red
Charge LED will be solid.
75% yellow The 75% Charge LED will slowly
LED pulse "On" and "Off", when the bat-
tery is less than 75% charged. When
the battery is 75% charged, the Yel-
25% 50% 75% 100%
low Charge LED will be solid.
100% green The 100% Charge LED will slowly
LED pulse "On" and "Off", when the bat-
tery is less than 100% charged.
When the battery is fully charged,
25% 50% 75% 100%
the Green LED will be solid, and the
25%, 50% and 75% Charge LEDs will
turn "Off".
UNDERSTANDING CHARGE LEDS
The PM400 has four Charge LEDs - 25%, 50%, 75% and
100%. These Charge LEDs indicate the internal battery's
state-of-charge (SOC). See below:
Error
Error LED Reverse polarity/
Solid Red Reverse the battery connections.
Explanation
Reason/Solution
Error
Error LED
Blinking Red
w/Cables Connected
Properly
Boost Light Does Not
Come On
w/Cables Connected
Properly
CHARGING THE PM400
Connect the PM400 using the included USB Charge Ca-
ble to the USB IN port and the USB car charger. It can
also be recharged from any USB powered port, like an AC
adapter, car charger, laptop and more. The USB IN port is
rated at 2.1 Amps to ensure safe and efficient charging
of the internal lithium battery. Due to FCC regulations,
we recommend not to charge and discharge the unit at
the same time.

CHARGING TIMES

The time to recharge a PM400 will differ based on the
discharge level and the power source used. Actual re-
sults may vary due to battery conditions.
USB Charger Rating
5A
Zeit 12 h
CHARGING YOUR USB DEVICES
You can recharge virtually any USB device, like a smart-
phone. Connect the included USB Charge Cable to the
USB OUT port and connect to your USB device.
Reason/Solution
The internal battery is too
hot/ Allow the unit to cool.
Bring the unit into cooler en-
vironment.
Connected battery is below
2-volts/ Remove all loads,
and try again, or use Manual
Override Mode.
1A 2A
6h 3h
21