Controlling Individual Or Multiple Shades - Home Decorators Collection SBAR01 Guía De Uso Y Cuidado

Operation
2
Calibration (Setting Movement Limits)
If you are installing multiple motorization
NOTE:
modules, each one must be calibrated separately.
CAUTION: Take care not to set the top/bottom calibration
positions beyond the physical travel of the shade. Doing so
may cause damage to the shade.
SETTING THE TOP POSITION
□ Press the toggle button (6) until the LED associated with the
desired shade module is selected.
□ Hold the Top Calibration button (2) for three seconds to set
the top position. LED on the shade module will flash.
□ Press the DOWN button (5) or UP button (4) to position the
shade at the desired top position.
□ Hold the Top Calibration button (2) for three seconds to
save the top limit position. The LEDs on the shade module
end cap will turn off and the remote LEDs will turn solid to
indicate a successful calibration.
□ Bottom position must be calibrated after making any
changes to the top position.
SETTING THE BOTTOM POSITION
□ Hold the Bottom Calibration button (3) for three seconds to
set the bottom position. LED on shade module will flash.
□ Press the DOWN button (5) to position the shade at the
desired top position.
□ Hold the Bottom Calibration button (3) for three seconds
to save the bottom limit position. The LEDs on the shade
module end cap will turn off and the remote LED's will turn
solid to indicate a successful calibration.
SETTING CUSTOM/FAVORITE POSITION
□ Using incremental movements of the up and down buttons
(4 or 5) to move the shade, select a position somewhere
between the top and bottom position limits as a custom or
favorite position.
□ Hold the Favorite button (8) for three seconds to save the
Custom/Favorite position.
3
Controlling Individual or Multiple
Shades
□ Use the Toggle button (6) to cycle through the shades that
have been paired and calibrated.
□ If more than 1 shade is calibrated to the remote, the Toggle
button (6) will give you the option to select ALL shades at
the same time.
□ While controlling one or all shades, hold the UP or DOWN
buttons (4 or 5) to incrementally move shade(s) in the
corresponding direction.
□ While controlling one or all shades, press and release the
UP, DOWN or FAVORITE button (4, 5, or 8) to move shade(s)
all the way to the top, bottom, or custom position.
□ Wait for the modules to come to a stop, then send the
modules to the bottom position by pressing the DOWN
button (5).
4
Factory Reset (Remote Control only)
□ Hold the Pairing button (1) for ten seconds to factory reset
the remote samples. All six LEDs will turn off.
6