ALLEN GROUP INT'L INC FF27428 Manual Del Usuario página 4

18. Periodically change the water. Clean the fountain water basin, the pump's outlet nozzle and PVC plastic tube for dirt
and debris with a damp cloth if necessary.
19. If the fountain is not going to be used for a long period time, remove the plug from the power supply outlet.
ASSEMBLY INSTRUCTIONS
Step 1: Remove the product from the box; place the base (B) on a level surface.
Step 2: Connect rabbet and slot between top portion (A) and the base (B), pay attention to have PVC plastic tube pass
through the slot and route out through the opening of the base (B).
Step 3: Connect PVC plastic tube to the outlet nozzle of pump (C), put the pump (C) in the bottom of the base (B) from the
opening of the base (B).
Step 4: Attach the cover plate (D), route the pump's (C) power cord out through the opening of the base (B).
Step 5: Fill the Base (B) with water. Make sure the pump (C) is completely submerged in water. The fountain is completely
assembled as shown in Fig 2. In order to have best effect, the water level should be ¾ inch below the opening of
the back.
Step 6: Plug the pump power cord to the wall outlet to run the fountain.
Reverse the steps in the assembly instructions to replace the pump (C).
Be careful not to spill water onto the plug of the pump.
DO NOT allow the pump to run dry!
PDF created with pdfFactory Pro trial version www.pdffactory.com
4