Miller api 970 Guia De Inicio Rapido

Item# 970 (Heated), 850 (Non-Heated) & WBU970 (Heated)
SPECIFICATIONS
(Model 970 & WBU970)
150 watts, 120 VAC, 60Hz
NOTES
(Model 970 & WBU970)
This product is approved for use with the LOCKNDRY®
extension cord. The plug on this product is specially
designed to mate with the LOCKNDRY® cord to form
a secure, water-resistant seal. See the instructions at
right for the LOCKNDRY® cord. LOCKNDRY® extension
cords may be obtained from your birdbath supplier
or contact the factory for information on a source
near you.
PRECAUTIONS
(Model 970 & WBU970)
1. Connect to a properly grounded outlet. Many
older homes do not have properly grounded
outdoor electrical outlets. Check with an
electrician if you have any doubts or questions
regarding your electrical ground.
2. Locate the bird bath where it will be away from
possible snow drifts.
3. Do not place the heated bath section directly
on the ground.
4. Do not immerse the heated bath section in
water.
5. Connect to a circuit that is protected by
Ground Fault Circuit Interrupter (GFCI). This is
a sensitive device that cuts off the electricity if
there is any leakage of current. This device may
be obtained from any electrician or hardware
store.
GENERAL
This bath was designed to be attractive to birds
in shape, slope, texture, and depth. Because of
these features, the bath has a rather large surface
area relative to the amount of water it holds. This
is typical of a well-designed bird bath. However,
these features will also accelerate evaporation, so
you may need to add water daily.
WARRANTY
This bird bath is warranted for a period of
12 months from the date of purchase. If you
believe your unit is defective and still within the
warranty period, return it to the place of purchase
for inspection and possible replacement.
BIRD BATH WITH STAND
INSTRUCTIONS FOR
BIRD BATH STAND
Tools needed: Phillips screwdriver
1. Locate the notch on the end of
each arm/leg. The notch will
line up with a tab inside the
bracket.
3. Once the legs are in place,
tighten the lower screw on
the bracket using a Phillips
screwdriver.
4. Repeat the procedure for the
three arms in the other end of the
bracket. Once they are in place,
tighten the upper screw on the
bracket.
5. Position the ring above the arms and slide the three
posts into the open ends of
the arms. The stand is now
complete.
Miller Manufacturing, Glencoe, MN 55336 USA • www.miller-mfg.com
Read Instructions Thoroughly Before Use
2. Slide the legs inside the
bracket, then rotate and push
until you feel the notch slide over
the tab. You should be able to
see that the ends of all three legs
extend equal distance into the
bracket.
6. Use the U-shaped wires to
stake the stand to the ground,
then place the birdbath within
the ring to complete the
assembly.
INSTRUCTIONS FOR THE
LOCKNDRY® CORDSET
FEATURES
- Plugs into any normal 3-prong outlet
- Mates with LOCKNDRY® plugs to form a
water-resistant seal
- Keeps connection from separating during use
- Second, locking nut for secure connections
INSTRUCTIONS
(1) Insert the plug
into the receptacle
just as you would a
normal extension
cord making sure
the plug is fully
inserted.
(3) Rotate the nut
to tighten the
plug against the
receptacle.
(5) Rotate the
red nut snuggly
against the larger
nut.
(2) Slide the large
nut forward
to engage the
threads on the
plug.
(4) Slide the
second, thinner,
red nut forward
to engage the
threads.
303902