Vertilux Vti 025 Serie Manual De Programación página 6

Readjusting the lower or an intermediate limit
1. Move the shade to the limit you want to readjust.
programming button
Press and hold the
on the back of the remote until the motor "jogs".
2.
Move the shade to the new desired position and
press stop. Then press and hold the
button located on the back of the remote until the
motor "jogs". The limit has been readjusted.
Setting motor into "sleep mode"
The following function is necessary only when more than one motor is programmed on the same
channel. Repeat the same procedure with all the previously programmed motors each time you want
to add a new battery motor into the same channel or modify an existing one and at the end wake up all
the motors.
METHOD A (applies to item numbers):
6-700-CM-24E04 | 6-700-CM-25E10
1. Press and hold the
the head of the already programmed motor, the
motor will "beep" and then
button down
holding the
"beep". The motor is now in "sleep mode". You
can now program another motor in the same
channel by repeating the procedure described in
the initial programming sequence.
METHOD B (applies to item number):
6-700-CM-35EB6
1. Press the programming button
on the head of the motor
(every time you press, the motor will "beep") and
hold the button on the fifth time until the motor
"jogs"
twice. You can now program another motor
in the same channel by repeating the procedure
described in the initial programming sequence.
"Waking up" the motor
1.
Press and hold the
head of the motor until the motor
located
programming
programming button on
"jog" once, but keep
until you hear a long
located
5 consecutive times
programming button
on the
"beeps" once.
© 2021. Vertilux, Ltd. All Rights Reserved. Last revised: May 2021.
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
vertilux.com
5