Suction Head Assembly; Operation - Kokido TELSA 30 Manual De Usuario

Suction head assembly

Insert the suction head directly into the suction mouth of the pool vacuum until the
side tabs of the transparent case clip in the holes of the suction head's pivot.
NOTE: To replace the brushes on the suction head, lift one end and pull the brush out
to make space for a new one.
WARNING!
For vinyl liner and fibreglass pools, it is recommended to keep the
brushes on the suction head to avoid damaging the pool.

OPERATION

WARNING!
 Do not use the pool vacuum if any damage is detected.
 Oil stain could occur due to possible leakage of lubricants applied to the O-ring.
 Do not operate this pool vacuum if there are people/pets present in the water.
 Make sure the pool vacuum is fully immersed in the water before initiating operation.
The minimum water level required to operate the device must reach above the
power button of the pool vacuum when it is held in a vertical position. Operating the
pool vacuum when not immersed in the water correctly can damage the unit and
the warranty will be voided as a result.
 Maximum operating depth in water is 3 meters (10ft).
 Maximum water temperature: 5˚C (41˚F) –35˚C (95˚F)
 DO NOT use the pool vacuum without an intact filter bag in place. Using your pool
vacuum without an intact filter bag in place will VOID your warranty.
 Suction entrapment hazard: This pool vacuum generates suction. Do not allow hair,
12