Error Indicators - Beta 1498CM/12 Instrucciones

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
• After the motorcycle has been started, disconnect the output lead with black clamp (-) from the mo-
torcycle's chassis.
• Disconnect the output lead with red clamp from the positive battery clip (+).
If the motorcycle cannot be started after the first few attempts, do not try again. Before attempting a new
start, leave the starter to idle for at least 5 minutes, to prevent it from getting damaged.
• Charge the starter after each use.
USING LED TORCH
• Press the ON/OFF button for 3 seconds – STEADY LIGHT.
• Press the ON/OFF button for 2 more seconds – FLASHING LIGHT
• Press the ON/OFF button for 2 more seconds – EMERGENCY LIGHT.
• To turn the LED torch off, keep the ON/OFF button pressed for 3 seconds.
Sequence: STEADY LIGHT – FLASHING LIGHT – EMERGENCY LIGHT – OFF.
USING STARTER AS A BATTERY CHARGER FOR ELECTRONIC DEVICES
The starter can charge several different types of mobile phones, smart phones, tablets, MP3/MP4 play-
ers, navigators and other devices with USB 5V- 2.1A output.
• Plug the USB charging cable into the starter.
• Connect the other end of the cable to the device to charge.
• Press the ON/OFF button; while the device is charging, the LED will go on.
• Do not charge two devices simultaneously: irreparable damage may occur.
After use, replace the starter in a dry area free from humidity. To clean the outside body, use a dry cloth.
REPLACING CIGARETTE LIGHTER PLUG FUSE
The fuse is located in the cigarette lighter plug. Make sure that the cable is not connected to the starter.
Loosen the ring nut on the plug head by hand; remove the damaged fuse and replace it with a fuse with
the same specifications. Lock the ring nut by hand.

ERROR INDICATORS

Any errors are indicated through acoustic and visual signals.
PROBLEMS
When the starting cable is
connected, a continuous sound is
emitted.
The starting cable does not start
after being connected to the
motorcycle battery (the LEDs are
flashing).
After the starting cable has been
connected to the motorcycle battery,
a steady red LED light is displayed
and an intermittent sound emitted.
After the starting cable has been
connected to the motorcycle battery,
a steady red LED light is displayed
and a continuous sound emitted.
The starter does not charge via ciga-
rette lighter cable – red LED off.
12
DEFECT
Internal battery flat.
Motorcycle battery voltage too low
(<1.5V).
Reversed battery cables.
A short-circuit has occurred.
A fuse has burnt out.
SOLUTION
Disconnect the cable and charge the
emergency starter.
Use different starting systems.
Disconnect the cables from the
battery and connect them correctly.
Disconnect the cables from the
battery and check the motorcycle, to
remove the short-circuit.
Disconnect the cable from the
starter and replace the damaged
fuse with a fuse with the same
specifications.
EN I