Tabla de contenido
Step 19
å
Push four HIDDEN CAMS (1F) into the SHELF (R). Then, insert the metal end of a CAM
DOWEL (2F) into each HIDDEN CAM.
å
Slide the SHELF MOLDING* (CC) onto the notched edge of the SHELF (R).
å
NOTE: The SHELF MOLDING (CC) is smaller than the FRONT BOTTOM MOLDING (M).
å
*U.S. Patent No. 5,499,886
Do not tighten the HIDDEN CAMS in this step.
Arrow
2F
Metal end
1F
R
Notched edge
Slide the MOLDING (CC)
onto the notched edge.
1F
CC
These surfaces
should be even.
Arrow
Metal end
2F
The groove
is closer to
this edge.
Page 25
Tabla de contenido
