Sanus VLF220 Manual De Instrucciones página 8

2
Mount the Wall Plate
Solid concrete or concrete block
2-1
Mark the wall
406 mm
(16 in.)
2-2
Drill pilot holes
2-3
Insert anchors and lag bolts
[18]
[18]
8
[02]
For assistance in determining wall plate location, see Height Finder
at sanus.com.
Level the wall plate [02] and mark the hole locations.
CAUTION:
Mount the wall plate [02] directly onto the concrete surface.
Minimum solid concrete thickness: 203 mm (8 in.)
Minimum concrete block size: 203mm x 203 mm x 406 mm (8
x 8 x 16 in.)
Minimum distance between fasteners: 406 mm (16 in.)
Drill pilot holes as illustrated.
CAUTION:
Pilot holes MUST be drilled to a depth of 89 mm (3.5 in.) using
a 10 mm (3/8 in.) diameter drill bit.
Never drill into the mortar between blocks.
89 mm
(3.5 in.)
Insert lag bolt anchors [18]. Then insert lag bolts [17] through the
wall plate [02] and into the anchors.
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid
potential injuries or property damage:
[02]
[16]
[17]
13 mm
(1/2 in.)
Avoid potential injuries or property damage!
Avoid potential injuries or property damage!
Avoid potential injuries or property damage!
Be sure the anchors [18]
seat fl ush with the concrete
surface.
Tighten the lag bolts [17]
only until the washers [16]
are pulled fi rmly against the
wall plate [02].
DO NOT over-tighten the lag
bolts [17].
10 mm
(3/8 in.)
6901-002111 05