Appliance Desk 4400/N Instalación

INSTALLATION GUIDELINES
FLOOR: Strong level surface
ELECTRICAL: 110-120V/60Hz 13A
WATER: Standard hot and cold connections
WATER PRESSURE
Standard water Pressure: 7.25-145 (psi) / 0.05-1(Mpa).
If more, reduce valves / install pressure reducing valves (Available)
VENTED DRYING: Requires a standard 4" vent hose to be installed.
REMOVE SHIPPING RODS
Remove the 2 shipping rods located at the back of the unit.
LEVEL THE UNIT
Check level by holding top and right of machine and shaking it.
Adjust feet using wrench if required.
BUILT-IN
Minimum clearances 2" on sides, 3" front and rear
DRIP PAN: It is recommended that all units have
drip pans for water safety. (Available)
DRYING
CONDENSING
(VENTLESS)
Exhaust Fan Plate Installed
VENTED
Exhaust Fan Plate Removed
Exhaust Duct Connected
Appliance Desk • 10216 Georgibelle Dr, Suite 900D, Houston, TX 77043-5249
Toll Free: 1-800-490-8018 • Email: [email protected] • www.ApplianceDesk.com
REQUIREMENTS
PRE-INSTALLATION
INSTALLATION
Display
Display
MODEL# 4400/N
CARPET
WOOD
SIDES FRONT/REAR