EUROM PAC 12 Folleto De Instrucciones página 14

 To use the dehumidification function, connect the water drainage hose to the water
drainage point (9). This hose should lead to a bucket or drain. The hose should not run
upwards! Your unit is now ready for use.
 In order to use the cooling
function, you do not need to
connect the water drainage
hose. Place window panel in
the window opening, see
diagram. The length of the
window panel can be
adjusted from 67.5 to 123
cm.
 Screw on the connector for
the air conditioner on one
end and the connector for the
window panel on the other end of the outlet hose.
 Slide the connector for the air conditioner into the appropriate slot on the rear of the unit.
 Secure the other end of the outlet hose in the window panel opening so that it can remove
hot air outside.
 You can also hang the outlet hose out of an open window; this method is less efficient
however.
 Avoid bends or pinches in the pipe. These will lead to a build up of damp, waste air which
can cause leaks, overheating or lead to the air conditioning unit switching off.
 Warning! Do not use your air conditioning unit until it has been installed according to the
instructions above!
 Warning! Ensure that water cannot penetrate the device!
 Warning! The length of the discharge pipe corresponds to the technique that is used in this
air conditioning unit. Do not replace or extend it using another pipe as this could have a
negative impact on the effectiveness of the unit. The hose can be stretched but must be kept
as short as possible in order to ensure optimum functioning.
 Don't forget about preventing access to burglars!
OPERATION
Operation panel
Operation panel and remote control have the same buttons.
↑
Remote control
14
→