Ultimaker S3 Guia De Inicio Rapido página 4

Install the Ultimaker S3
When placing the printer on a shelf or table, take proper measures to prevent the
printer from falling.
1. Insert the spool holder
into the back panel
and push until it snaps
into place
4. Slide the glass plate
into the rear build plate
clamps, then close
the front clamps and
glass door
2. Connect the spool
holder cable to the
NFC socket and secure
behind the cable clips
5. Connect the power
cable to the printer
and the other end to a
power outlet
3. Open the glass door
and the front build plate
clamps to insert the
glass plate
A power outlet with
an earth connection
must be used. Be
sure that the building
installation has
dedicated means
for over-current and
short-circuiting.