Hydrofarm JUMP START Guia De Inicio Rapido

THE JUMP START® HEAT MAT THERMOSTAT
The Jump Start Heat Mat Thermostat™ is a digital temperature control
device that allows gardeners to select and maintain optimum rooting
temperatures for faster seedling or cutting growth. It is compatible with all
Jump Start Heat Mats and most other seedling heat mats.
SET UP THE THERMOSTAT
1. Insert the probe approximately 1" – 1½" into the rooting area.
2. Position the thermostat up and away from seedling trays and stray
water. DO NOT SUBMERGE THE THERMOSTAT.
3. Plug the heat mat into the thermostat.
4. Plug the thermostat's power cord into the power source/electrical
outlet. The POWER LED lights up.
5. Set the maximum desired temperature for the heat mat.
USING THE CONTROLLER
1. Press the SET button to display the current pre-set temperature. The
thermostat's LED screen shows the current temperature whenever the
SET button is not activated.
2. Press and hold the SET button until the LED starts to blink, then you
are able to adjust the temperature up or down by pushing the
or (DOWN) arrows. The thermostat's LED screen shows the numbers
as you cycle through them. Press the SET button again to set the chosen
temperature. The HEATING light cycles on when the mat is in the process
of heating. When the LED is not lit, the mat is not providing heat. The light
turns off automatically when the mat reaches the pre-set temperature.
3. Press and hold the (DOWN) arrow button for three seconds to
display the temperature in Celsius. Press and hold the
button to display the temperature in Fahrenheit.
TIPS
The Digital Heat Mat is designed to achieve the desired heat temperature
within five hours. If it takes longer than five hours, or if the mat runs for
longer than 5 hours, desired temperatures are not being reached. To
conserve power and increase the mat's effectiveness, move the mat to a
more insulated surface. You can also add a humidity dome to cover the
seedling tray, which aides in heat retention.
WARNING: DO NOT IMMERSE CONTROLLER IN WATER.
If the probe's temperature reaches 108 degrees F, the automatic safety shut-
off is activated.
In the event that you would like to use your thermostat to control air
temperature, we've included a suction cup so that the probe can be
mounted outside the rooting area. Simply clip the suction cup over the
probe and apply to desired area. It
may help to moisten the suction cup
prior to sticking it.
WARRANTY:
Heat Mat Thermostat is guaranteed
to the original owner for one full
(UP)
year against defects in workmanship
and materials. Save your receipt – a
copy is required for all warrant
work. Return the Heat Mat to your
place of purchase.
(UP) arrow
The Jump Start