Installing The Bx-Ch34; Initializing The Bx-Ch34; Adjusting The Bx-Ch34 - Metra Electronics Axxess BX-CH34 Instrucciones De Instalación

Installing the BX-CH34

With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the LD-BX-CH3
or LD-BX-CH4 harness, into the interface.
• Connect the LD-BX-CH3 or LD-BX-CH4 harness into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
Note: If retaining steering wheel controls, ensure the jack/wire is connected
before proceeding to the next step.

Initializing the BX-CH34

• Turn the key to ignition, the L.E.D. inside the interface by the 16-pin harness
will turn on solid Red.
• After 30 seconds the L.E.D. will turn off for a few seconds, and then flash up
to 16 times depending on what radio it sees connected to it, and then turn off
again. Refer to the L.E.D. feedback section for more information.
Note: If the L.E.D. does not turn off, it is not communicating to the vehicle.
Turn the key off, check all connections, and then try again.
BX-CH34

Adjusting the BX-CH34

Audio level adjustment (factory amplified models only):
• With the vehicle and radio turned on, adjust the volume up 3/4 of the way.
• With a small screwdriver, adjust the potentiometer clockwise to raise the audio
level; counterclockwise to lower the audio level.
• Once at a desired level, your audio level adjustment is complete.
6