Resetting The Unit - Stanley POWERMAX RT901 Manual Del Usuario

REMOTE PAIRING
1. Locate the power button on the power strip.
2. Press and hold the power button for 3
seconds. The LED power indicator beneath
the button will begin to flash slowly.
3. On the remote control (LED indicator still
flashing) press the top of the switch (on),
wait 2 seconds, and then press the bottom
of the switch (off). The LED indicator will
now stop flashing.
4. You have successfully paired the transmitter
to your receiver.

RESETTING THE UNIT

You can reset and remove all paired remotes from your power strip by
doing the following:
1. Press and hold the power button on the power strip for 3 seconds.
The LED indicator will begin to flash slowly. Continue to hold for an
additional 3 seconds. The LED indicator will now begin to flash rapidly.
Release the POWER button for 1 second and press once again to confirm
reset. The LED indicator should now be OFF.
2. Your unit has now been reset and does not have any paired transmitters.
(Note: After reset, pairing is required to use the transmitter shipped in
this package.)
BATTERY INFORMATION AND REPLACEMENT
The remote control uses one 3-volt CR2032 lithium battery.
To replace, slide out the battery tray located at the bottom
of the transmitter. Insert one new CR2032 lithium battery,
making sure to orient the battery so that the positive side (+)
is on the side of the tray with the positive marking (+). Slide
the cover back in. To test, press the switch on the remote to
make certain the LED lights up. Do not dispose of battery in
fire. Battery may explode or leak.
3 VOLTS
CR2032
The remote
control uses
1 3-volt
CR2032 lithium
battery