Tabla de contenido
(9-pin USB_8_9)
(see p.2 No. 34)
USB 3.0 Header
(19-pin USB3_4_5)
IntA_P4_SSRX-
(see p.2 No. 16)
IntA_P4_SSRX+
IntA_P4_SSTX-
IntA_P4_SSTX+
IntA_P4_D-
IntA_P4_D+
Infrared Module Header
(5-pin IR1)
(see p.2 No. 39)
Consumer Infrared Module Header
(4-pin CIR1)
(see p.2 No. 37)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2 No. 41)
1. High Defi nition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows
Select "Mixer". Select "Recorder". Then click "FrontMic".
ASRock X79 Extreme6/GB / X79 Extreme6 Motherboard
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
Besides four default USB 3.0
Vbus
Vbus
ports on the I/O panel, there is
Vbus
IntA_P5_SSRX-
IntA_P5_SSRX+
one USB 3.0 header on this
GND
motherboard. This USB 3.0
GND
IntA_P5_SSTX-
IntA_P5_SSTX+
header can support two USB
GND
GND
IntA_P5_D-
3.0 ports.
IntA_P5_D+
ID
1
This header supports an
IRTX
+5VSB
optional wireless transmitting
DUMMY
and receiving infrared module.
1
GND
IRRX
This header can be used to
1
connect the remote
GND
IRTX
IRRX
controller receiver.
ATX+5VSB
This is an interface for front
GND
PRESENCE#
MIC_RET
panel audio cable that allows
OUT_RET
convenient connection and
1
control of audio devices.
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
®
XP / XP 64-bit OS:
47
Tabla de contenido
