SAFETy PRECAUTIONS
CAUTION
If the floor is wet or has wet
spots, wipe them up before
using the Robot Cleaner. Do
not use the Robot Cleaner on
a wet surface.
Doing so can cause product
failure.
When attaching the mop,
ensure that it is fitted
correctly so that it does not
block the lower camera
sensor.
Blocking the bottom camera
sensor may not allow the
product to work correctly.
To save energy when the
Roboking is not in use for
longer periods, turn off the
power switch, and turn on the
power switch again just prior
to using the Robot cleaner
again.
Tip
Check the following items before use:
• Empty the dust bin after each operation or prior to it filling up.
• Remove any cables or long strings from the floor.
• Remove any moisture from the floor before cleaning.
• Close the cover of the dust bin before cleaning.
• Remove fragile or unnecessary objects from the room to be cleaned.
For example, remove expensive ceramics and valuables from the floor.
• Confirm whether the battery has sufficient power, and if it is low, recharge it.
• Close the doors of any room that you do not want the Robot Cleaner to enter.
During cleaning, the Robot Cleaner may enter another room and continue cleaning.
• Do not use this product in the room where a child is sleeping alone. The child can be hurt or
woken.
• Remove towels, foot towel or any other thin cloth from the floor as they can get caught by the
brush.
• Before starting the device, it's better to remove carpets that are thicker than 20 mm as they
may cause it to malfunction.
• Please close any balcony doors as the wheels may get stuck while cleaning.
6
When the robot cleaner is
operating, it may hit the chair
leg, desk leg, table leg or
other narrow pieces of
furniture.
For quicker and better cleaning,
place the dining chairs on top of
the dining table.
NOTE: Very low thresholds
will allow the Robot cleaner
to go over them and perhaps
into an undesirable location.
Make sure that all the doors
of the rooms that are not to
be cleaned are closed.