Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING
READ AND FOLLOW ALL INSTRUCTIONS
WARNING-TO REDUCE THE RISK OF INJURY, do
not permit children to use this product unless they are
closely supervised at all times.
CAUTION- This product is for use with storable pools
only. Do not use with permanently-installed pools. A
storable pool is constructed so that it is capable of
being readily disassembled for storage and reassem-
bled to its original integrity. A permanently-installed pool
is constructed in or on the ground or in a building such
that it cannot be readily disassembled for storage.
CAUTION- Do not touch the panel surface when the
product is working or you may get hurt.
NOTE: Do not sit, stand or jump on this product.
NOTE: Weather conditions can affect the performance
and life span of your solar water heater.
NOTE: This product must be set up on a flat and clean
location; the ground must be cleared of all objects and
debris including stones and twigs.
NOTE: Grass or other vegetation under the product will
die and may cause odors and slime to develop,
therefore we recommend removing all grass from the
selected location. Avoid locating the item over of beside
areas prone to aggressive plant and weed species as
they may damage the item when they grow.
NOTE: This product must be placed in direct sun light
to ensure proper performance.
NOTE: Drawings for illustration purpose only. May not
reflect actual product. Not to scale.
SPECIFICATIONS
Surface(m
)
2
Length(m)
Width(m)
Max Pressure(Psi)
Material
Channel System
Installation
Characteristic
3.41
2.84
1.2
10
PVC
S-channel
On Lawn/On Flat
50-100% of the swimming
pool surface (Increase
swimming pool water
temperatures by
approximately 3-5˚C
(5-9˚F) Depending on the
weather condition
NO.
DESCRIPTION
1
Heat Panel
2
O-ring (Φ24mm)
3
Hose Adapter
4
Adapter Nut
5
Hose Clamps
6
Hose (Φ32 x 1000mm)
7
Adapter Cap
8
O-ring (Φ56mm)
To order spare parts for the Pool Solar Water
Heater, please provide us with part no. and
part name.
ASSEMBLY INSTRUCTIONS
1. Unplug the sand filter. Loosen the hose clamps on
the pool's inlet and outlet valves, replace the debris
screens with stopper plugs (or close the connection
valves) to stop water to flow.
2. Follow the below diagram instruction to assemble all
the parts properly;
NOTE: Refer to the sand filter's owner's manual for
assembly.
3. Loosen the hose clamps on the pool's inlet and
outlet valves; replace the stopper plugs with debris
screens (or open the connection valves of the pool)
to allow water to flow.
4. Tighten the hose clamps, ensure no water is leaking
and every connection is securely fastened.
2
SPARE
QTY.
PART NO.
1
2
P6005
2
P6618
2
P6615
2
P6124
1
P6176
2
P6540
4
P6029
Tabla de contenido
