teutonia Delta 04 Instrucciones De Manejo página 8

- Delta/Prestige
● Make sure that no locks disengage while the bug-
gy/pram is carried over obstacles (e.g. steps).
● When readjusting the buggy/pram make sure that your
child is clear of moveable parts.
● The buggy/pram can be damaged or destroyed by
overloading, improper folding or use of unapproved ac-
cessories.
Parking Prams/Buggies Provided with
Air Wheels
CAUTION: It is possible for the tyres to stain floor cover-
ings.
Related complaints or claims for compensation will not
be admitted.
Cleaning the textile parts
To remove small stains, use a cloth dampened with clear
water and carefully clean the spot. Avoid brisk rubbing
(especially on dark fabrics). Normally, all removable fabric
parts can be washed in the washing machine with a fine
fabric detergent (no brightening agents) at 30 °C/85 °F
(gentle cycle). Please check separate care labels on the
fabric parts.
Removing the seat cover
with fall-out protection
at unit. Remove the press studs and pull the insertion
pieces of the metal bar out of the armrests (snap lock).
Then pull the metal bar out of the textile cover.
During assembly ensure that the insertion pieces are in
the correct position.
Rain Cover
In rainy weather fit the rain cover over the entire bug-
gy/pram before it starts to rain. CAUTION: The rain co-
ver is not a toy! Never leave your child unsupervised. For
the best possible ventilation of the buggy/pram we re-
commend using the rain cover only for the duration of the
rain shower.
8
The side covers provided be-
neath the armrests and atta-
ched to them with Velcro fas-
teners can be removed to
improve ventilation. If slightly
soiled, the seat cover with
fall-out protection can be wi-
ped with a damp cloth. In ot-
her cases, e.g. to wash it, it
can be removed from the se-
Removing the Hood Cover
the hood bars from the guide loops. After washing, reassem-
ble in reverse order. In this process make sure that the front
and back bars are not confused with each other.
Unfolding the Chassis
Folding the Chassis
Assembling and removing the wheels
Before washing, the two hood
bars have to be removed from
the cover as follows (see
sketch): 1. Use a coin to turn
the covers 1 on the hood joints
by 90° and remove them.
2. Separate the hood front bar 3
and the back bar 2, including
the plastic bearings, from the
push-in part 4. 3. Carefully pull
Pull up the folding handle 1
(hand grip) up as far as it
will go. The handle lock 2 en-
gages and the arrester lever
3 automatically moves over
the tube as an additional
safeguard. Prior to use make
sure that all catches have
latched.
Press both release buttons
1 so that the chassis can
be folded. Release the ar-
rester lever 2 (by raising it)
and swivel the handle over to
the other side. You can re-
duce the storage size further
by folding down the top of the
handle.
Before assembling or remo-
ving the wheels, press the
locking spring 1. When as-
sembling the wheels, make
sure that the locking spring
engages properly.