Style selections SSDPS3272CLSV Manual De Instrucciones página 8

ASSEMBLY INSTRUCTIONS
8. Move glass panel (B) to closed position. Using a
pencil, mark along the outside glass panel (B) for
placement of magnetic strike in step 11.
9. Set strike adjustment rail (E) along mark made
in step 8. Use a level to ensure strike adjustment
rail (E) is plumb. Mark the three pre-drilled hole
locations. Remove strike adjustment rail (E).
Using a drill, drill holes approximately 1-1/2 in.
deep into each marking.
NOTE: if installing into tile, use 1/4 in. masonry
bit and proceed to step 10a. If installing into an
acrylic or fiberglass shower enclosure, use 1/8
in. drill bit and proceed to step 10b.
10a. Tile installation: Insert wall anchors (FF) into
each drilled hole using rubber mallet. Place
strike adjustment rail (E) back into place.
Tighten 1-1/2 in. screws (GG) with Phillips
screwdriver into each wall anchor (FF). Press
screw caps (EE) over each 1-1/2 in. screws (GG).
Note: When installing strike adjustment rail (E), the
small holes along the side must face the inside of
shower enclosure.
Hardware Used
FF Wall Anchor
GG
1-1/2 in. Screw
EE Screw Cap
8
9
10a
x 3
x 3
x 3
8
B
E
GG
EE
H
E
FF