Veranda 34107611BOM Instrucciones De Instalación página 6

Install Decorative Rail Cover Connectors:
11
a. At about ⁄ " from each post, place decorative rail ⁄ ⁄ ⁄
1 1 1
cover connector, centered on rail (Fig. 14).
b. Use a ⁄ ⁄ ⁄ " drill bit to drill through the top rail on each ⁄
1 1 1
8 8
side of connector.
c. Drive #8 x 1" screws through holes to connect the
connectors to the top rail (two per connector) (Fig. 15).
d. Use a at head screwdriver to pry out center tab of
connector (Fig. 15).
e. Repeat for connector on opposite side of adjascent
post.
f. Place remaining connectors on top rail, spaced evenly
along the length of railing (Fig. 16)
Install Decorative Rail Cover:
12
a. Measure distance between posts and cut decorative
rail cover to measured length.
b. Place decorative rail cover on top of connectors and
snap into place. Press down on cover, starting from
one end, working your way down (Fig. 17).
NOTE:
• Decorative rail covers are not recommended for
use on angles. If done however, please note the
decorative rail cover will t over the top of the angle
bracket, and wowuld need to install ush ato the
end of the bracket. This will leave an exposed end
of the rail cover.
• Decorative rail covers are not recommended for
use on stairs. If done however, please note the
decorative rail cover will t over the top of the stair
bracket, and would need to install ush to the end
of the bracket (Fig. 18).
6
2 2
Fig. 14
Fig. 15
#8 x 1"
Screws
Center Tab Center Tab
Fig. 16
Fig. 17
Fig. 18