Module Wfc01" Total Reset - Biasi Connect Manual De Instrucciones

•
create and enter a univocal login Password (at
least 6 characters) for this specific device ( =
system / "Module WFC01")
The password is mandatory.
•
Since no password
provided for, note down Device name and
Password to retrieve them in case of replacement
or reset of the device or if the APP is reinstalled
•
In the event of a total Reset or reconfiguration of
the "Module WFC01", it will instead be possible to
enter the same Device name and Password
again with the advantage of keeping the
configuration valid on all other smartphones
•
In case of loss of the credentials, perform a
"Module WFC01" total reset (see page 14), create
new ones, Reconfigure the "Module WFC01" as
described in this paragraph and, if other
smartphones are
system(s), enter the new credentials also in them.
Press and go to Phase 3 - CONNECTIVITY SETTINGS,
where you will enter the data that will allow the
"Module WFC01" to access your WiFi network and be
reachable via WEB
•
in the menu "Connection mode" leave (or select)
the default setting "Automatic, local and remote"
•
in the menu "SSID WiFi", select the name of your
WiFi network among the detected and listed ones
If your WiFi network is hidden, select "Enter
manually", which is the last item of the list, and
enter the WiFi exact name
•
Enter the Password of your WiFi network in the third
box. Is not possible connect the device to a WIFI
network without a password.
Press and go to Phase 4 - SYSTEM CONFIGURATION,
where you just have to select RINNOVA from the menu
"Type of installation".
recovery procedure
enabled to control
is
•
Click on Save device; wait for the short saving
time to end until the "Installation complete"
screen is displayed to confirm that the operation
was successful, and click on the check mark
button
Now, the configuration is complete and the
•
"Module WFC01" disables its Hotspot  on your
smartphone, access Settings > Wireless and
networks and reconnect it to your usual WiFi
(home) network
the
•
The identification code of your device is now
visible on the display. The check mark indicates
that the data exchange with the device has been
established.
•
If the device is "not available", search for
availability
"Module WFC01"
Configuration is complete.

"Module WFC01" total reset

The Total reset (reset to factory settings) is to be
performed only in exceptional cases, for example:
•
when trying to restore operation after device's
malfunctions that could not be diagnosed
•
in case of loss of the credentials necessary to
access the device
•
Hold R key pressed for at least 10 seconds, until the
green LED 3 starts flashing.
Note: the R key is inside the box and is activated by
pressing the upper cover at the centre of the area
shown in the figure:
P a g _ 14 | 36
through the Refresh
R
command.