Polaroid OneStep+ Manual De Instrucciones página 24

Safety Information
Caution
risk of electric shock
disassemble the motorized roller system
• Do not disassemble the device. Incorrect
reassembly can cause electrical shock if
the device is used again.
• Do not immerse the device in water or
other fluids.
• Do not operate the device in a high humidi-
ty environment or very dusty environments.
• Do not attempt to tamper with, adjust or
remove the battery and/or the electronics
located below the rollers behind the
device's film door.
• Do not attempt to remove the door itself as
it is connected electronically to the body
of the device. Doing so is unsafe, will likely
damage your device, and will void your
warranty.
• Do not insert metal objects into the device.
• Do not insert any objects into the rollers
or gears.
• Keep small children and infants away from
device to avoid them being injured by the
device's moving parts.
• Do not use or store the device near any
heat source or any type of equipment that
generates heat, including stereo amplifiers.
• Do not use the device near flammable or
explosive gases.
• Do not charge the device if you notice any
unusual odors, noise or smoke.
• Do not attempt to disassemble the film's
battery or modify it in any way (if using
600-type film). If battery fluid gets in your
eyes, immediately rinse your eyes with
fresh, cold running water and seek medical
attention immediately.
• Do not cover the flash.
Battery and Charger
• This device uses a custom lithium-ion
battery that is non-removable and mounted
inside the camera body.
No other type of battery can be used. Battery
replacement can only be done by authorized
service centers. The battery will provide
many years of service if properly used.
• Power consumption varies depending on
the environment the device is used in and
how the device has been stored. Used im-
mediately after full charge, the battery will
power the processing of up to 20 film packs
with flash exposures. Due to the high energy
— / requirements of the flash, we recommend
do not open
charging the camera fully before every
session for best results.
• Once the battery energy level falls below a
certain level, the device will no longer pro-
cess film. The LED will blink and signal when
it needs to be recharged. This is to avoid a
photo getting stuck as it is being processed
through the roller system.
• The rechargeable battery is not fully
charged at the time of purchase. Charge the
battery fully with the USB charging cable
(provided). This usually takes 1-2 hours (can
vary depending on usage).
• The supplied battery charging cable has
been tested to work with the Apple iPhone
power adaptors. While it can be used in
other USB ports e.g. computer, USB power
adaptors, TVs, cars etc., correct operation
cannot be guaranteed.
• When the device is no longer in use, please
recycle it properly.
Usage Environment
• To protect the high-precision technology
contained in this device, never leave the
camera in the following environments for
extended periods of time: high tempera-
ture (+42°C/108°F), high humidity, places
with extreme changes in temperature (hot
and cold), direct sunlight, sandy or dusty
environments such as beaches, damp
places, or places with strong vibrations.
• Do not drop the device or subject it to
severe shocks or vibrations.
• Do not push, pull or press on the lens.
Compliance
Important directions for using
Lithium–Ion Batteries
1. Do not throw into fire.
2. Do not short circuit.
3. Do not disassemble.
4. Do not continue to use when damaged.
5. Dispose correctly after use.
6. Keep away from water.