Idiomas disponibles
Idiomas disponibles
Maintenance
A
Replace the battery (1) by removing the three screws (2) securing the battery
cover (3).
B
Use a small screwdriver (4) to gently pry the battery loose.
C
Insert a new battery (5) by sliding the edge of the battery below the gold clip (6).
Ensure the positive (+) side of the battery is facing up. Use only a CR2032
replacement battery.
D
Push the end of the battery opposite from the gold clip down.
A
Re-install the o-ring (7) and secure the battery cover (3) with screws (2).
Care and Cleaning
Care should be given to the cleaning of this product. Although its finish is extremely
durable, it can be damaged by harsh abrasives or polish. To clean, simply wipe
gently with a damp cloth and blot dry with a soft towel.
Warning: Scrubbing Bubbles
®
Cleaner must not be used on the remote. Use of these cleaners can crack or
severely damage the remote. If overspray gets onto the remote, immediately wipe it
dry with a soft cotton cloth.
Note: Do not submerge the remote control.
70000 Odyssey Remote
The 70000 Odyssey Remote is offered to enhance your Odyssey shower experience
by adding convenient remote control of several frequently used functions. Functions
can be started or stopped up to 20 feet from the shower.
Sync the remote
Note: The remote control must by synced to the shower before using it to
control the shower.
From your shower, touch the Display and the Delta logo briefly appears while the
Startup Screen is loading. Select the Settings button and step through the features
to get to the Wireless Control screen. Push the Sync Remote button, then follow the
on screen instructions.
Personalized Presets
Allows any of the four available presets to be started. Warm-up Initiates the shower
Warm-up program. Additional details on customizing the presets, Warm-up and the
default shower program can be found in the E20000 installation instruction.
Power
If the shower is off, this button initiates the shower default program. If the shower is
on, this button turns it off.
LED Indicator
A brief flash of green light indicates an RF signal has been sent as the result of a
button press. The LED will flash red as the result of a button press to indicate a low
battery condition and the battery should be replaced.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment under FCC rules.
Bathroom Cleaner and Lysol
®
A
Basin Tub and Tile
C
Warm-up Button
The 70000 Remote
Control includes optional
rubber plugs (8) that can
be used to cover the
screws in the back of the
remote, if so desired.
2
2
3
RP77025
Battery Cover
7
1
5
6
Preset Buttons
Preset Buttons
8
B
4
D
LED Indicator
Power Button
8
80376
Rev. B
