Tabla de contenido
Idiomas disponibles
Idiomas disponibles
840189501 ENv03.qxd:840168500 Ev01.qxd
Setting Alarm Time
SETTING ALARM MODE:
Slide Alarm Mode switch to desired setting: Music or Buzzer.
The corresponding mode will be indicated on the LCD display.
TO SNOOZE:
Press the Snooze/Dimmer button after the alarm sounds.
TO DEACTIVATE THE ALARM:
Current alarm time and wake mode can be viewed on the
display. Slide the Alarm Mode to OFF position to deactivate.
Setting the Brightness of the Display
Press the Snooze/Dimmer button during normal operation to adjust
the brightness of the LCD display.
Operation
HOW TO INSTALL/REPLACE BATTERY:
Remove the plastic tab from the battery cover; then remove the
battery cover on the bottom of the unit using a screwdriver.
This unit contains 2 AA batteries as a backup power source. The
battery keeps the clock and the alarm operating in the event of a
power interruption.
PLAYING THE RADIO
1. Press the Radio ON/OFF button.
2. Select AM or FM mode.
3. For manual tuning, use the Tune + and – buttons to select
station.
4. For preset tuning, select preset buttons 1–5.
5. Adjust volume using the Volume + and – buttons.
5/10/10
4:10 PM
(cont.)
6
Page 6
Operation
(cont.)
Remove top cover using the finger latch.
SETTING RADIO STATIONS
1. Turn on radio.
2. Select AM/FM mode.
3. Tune the radio to a desired station using the Tune + and –
buttons.
4. To program the selected station as a preset, press and hold the
Station Set button. While holding the Station Set button, press
one of the 1–4 preset buttons. The corresponding number (1–4)
should appear in the display.
5. Repeat steps 1–4 for setting the other radio stations.
6. Remove clear plastic button covers and place punched-out
cardboard cutouts of radio genres onto button.
7. Replace clear plastic button covers; then replace top cover onto
unit.
CHARGING AN iPod:
1. Connect an iPod to the iPod connector. The iPod will begin
charging.
2. To remove the iPod from the iPod line, squeeze the sides of the
connector and pull away from the iPod.
PLAYING AN iPod:
1. Connect an iPod to the iPod connector.
2. Press the Radio ON/OFF button.
3. Press the iPod #5 preset button.
4. To use an iPod, refer to the user's guide for your iPod.
NOTE: Hamilton Beach cannot accept responsibility in the event that
data recorded on an iPod is lost or damaged when using an iPod
connected to this unit.
7
Tabla de contenido
