Troubleshooting; Technical Parameters - BluMill EP1069-GS Manual Del Usuario

TROUBLESHOOTING

EN
Problem Possible causes
ADD WATER indicator turns Low water level or lack of
on water
The water screen at the
bottom of water reservoir is
blocked.
Pump malfunction.
ICE FULL indicator lights up Ice basket is full and the
infrared light is blocked by
the ice.
Infrared light-emitting diode
& light-receiving diode do
not work
ADD WATER and ICE FULL The ice tray is not in the
indicators turn on simulta- right position.
neously
The ice collects together. Making ice takes too much
time.
The water in the water
reservoir is of too low tem-
perature.
8
Solution
Stop making ice, refill water
and then press "ON/OFF"
key to restart ice-making
cycle.
Do cleaning
Send it to the authorized
department for repair.
Remove the ice from ice
basket.
Wipe up the foreign objects
on the infrared light-emit-
ting diode & light-receiving
diode and restart the ice
maker.
Call Customer Service if the
infrared light-emitting diode
& light-receiving diode still
can not work after wiping
up the foreign objects on
them and restarting the ice
maker.
Check if the ice tray is bloc-
ked by something.
Unplug the appliance and
plug it again, then restart
the appliance.
Stop making ice and restart
the ice-making cycle after
the ice melts.
Fill the water reservoir with
water ranges between 8ºC
and 25ºC.
Problem Possible causes
The ice-making cycle The ambient temperature
seems normal but no ice is or water temperature is too
produced. high.
Refrigerating system leaks
Refrigerating system
blocks
Poor ice-making result Poor heat dissipation.
The water temperature is
too high.
The ambient temperature is
too high.

TECHNICAL PARAMETERS

Model: EP1069-GS
Applicable climate: ST/SN/N/T
Class: I
Power source: 220-240V/50Hz
Rated power: 105W
Refrigerant/Refrigerant amount: R600a/28g
Foaming agent: C5H10
Net weight: 9.03Kg
Housing: ABS
Unit size*DXWXH)* 348*248*295mm
ENVIRONMENT FRIENDLY DISPOSAL
Solution
EN
Start the ice-making cycle
at a environment with an
ambient temperature less
than 32°C and fill the water
reservior with some cold
water.
Call customer service
Call customer service
Leave an 8-inch clearance
on all sides of the ice ma-
ker for proper ventilation.
Fill the water reservoir with
water ranges between 8°C
and 28°C
Operate the ice maker at a
environment with an ambi-
ent temperature between
10°C and 32°C.
9